batte melt pump

How to make melt pump flow stable

Flow stability method: the first use of melt pump must be filled with pump body as priming water. When the suction pipe is to be absolutely sealed and started, the flow is not stable. It is normal because it is stable after exhausting air.

Good sealing and wear resistance of melt pump

All gears and mating surfaces of the melt pump produced by our company are finely ground and assembly clearance is strictly controlled to obtain accurate flow. ZB-B series of gear and pump body adopt chromium-nickel alloy steel and high tem

Extruder and Melt Pump Enhance Melt Mixing Ability and Output

Generally, using the existing conventional single screw extruder in series with the melt pump , conservatively estimates, the output will also increase by 10% - 15%. According to rough estimation method, the output can be increased by 5%-7%

Effect of Mechanical Installation Accuracy on Driving Torque

The control part of the melt pump is usually composed of frequency conversion motor, gear transmission, transmission shaft and so on. In the process of installation, it is necessary to find the concentricity of the input shaft and the outpu

Points for Attention in Dismantling Polypropylene Metering Pu

Polypropylene metering pump conveys dangerous chemicals. When TEAL transported by the pump ignites with air and explodes in water, if the treatment is not clean, it is easy to cause casualties when the pump head of the polypropylene meterin



©2019 Batte Mechanical Zhengzhou Co,.Ltd. All rights reserved. sales@battemachinery.com
Batte is a professional screen changer manufacturer, supplying screen changer, especially screen changer for extrusion mould