192

Extrusion gear pump how to install will be more convenient?1, we recommend using a suction line from irrigation installation, aspiration side of the pump sump below the minimum level. If you must use a suction lifting type of installation, y

112

thermoplastic extrusion pump inlet inlet bearing right 　　Many machine hand that this practice can improve the lift, had the practice of thermoplastic extrusion pump head = total lift ~ loss of lift. When the thermoplastic extrusion pump

100

(L) thermoplastic extrusion pump disintegration and cleaning, heating and cooling, should be strictly in accordance with the start-stop operation, in order to avoid unnecessary losses. (2) should pay attention to maintaining a stable populat

117

thermoplastic extrusion pump is polyester melt conveying, pressurization and melt metering essential equipment. Than other types of high temperature melt pump pump compact, reliable operation, low energy consumption, high volumetric efficien

56

① tooth repair: Whetstone removed with fine emery cloth or strain or multi-angled ground to the site, and then swap gear surface orientation and appropriately for research, and finally cleaned; severe wear can be observed with the naked ey

89

High viscosity oil will produce noise, you must use the appropriate oil viscosity. 2, less than the output flow