+86-371-67991755
Request Quote
Flow stability method: the first use of melt pump must be filled with pump body as priming water. When the suction pipe is to be absolutely sealed and started, the flow is not stable. It is normal because it is stable after exhausting air.
All gears and mating surfaces of the melt pump produced by our company are finely ground and assembly clearance is strictly controlled to obtain accurate flow. ZB-B series of gear and pump body adopt chromium-nickel alloy steel and high tem
Generally, using the existing conventional single screw extruder in series with the melt pump , conservatively estimates, the output will also increase by 10% - 15%. According to rough estimation method, the output can be increased by 5%-7%
The control part of the melt pump is usually composed of frequency conversion motor, gear transmission, transmission shaft and so on. In the process of installation, it is necessary to find the concentricity of the input shaft and the outpu
Polypropylene metering pump conveys dangerous chemicals. When TEAL transported by the pump ignites with air and explodes in water, if the treatment is not clean, it is easy to cause casualties when the pump head of the polypropylene meterin
Extruder gear pump
Booster melt pump
Rubber extrusion pump（ZB-R）
thermoplastic extrusion pump
External lubrication type melt
